Overview | 1-7
Supplemental Information – Where Can I Find It?
Some analyzers are configured with optional equipment that may require
supplementary information. The analyzer Operator’s Guide and this ad-
ditional information (not part of the main manual) – collectively known as
the Documentation Package – is included with the manual.
If a CD of the analyzer Documentation Package is ordered, this infor-
mation is also included in the “Supplemental Information” folder on
the CD.
The Documentation Package shipped with each analyzer includes the
following:
• Manual Supplements that describe and illustrate installation, operation,
layout, and maintenance procedures for non-standard Measuring Cells*
or optional equipment*, non-standard (derivative) analyzer models,
or information that is intended to replace similar information in the
Operator’s Guide. (*These documents can also include a non-standard
Spare Parts List or a separate Custom Spare Parts List.)
• Analyzer Programming Parameters sheet, which lists the critical analyzer
operating parameters.
• EEPROM Data Sheets, which list the factory-default configuration set-
tings of all programmable analyzer parameters.
• Signed Final QC (Quality Control) Document, which includes AMETEK
Testing Quality Control information for the analyzer.
• Final As-Built drawings which are customer-specific drawings for the
analyzer system.
• Other customer-specific information may also be included (if appli-
cable), such as Product Data Sheets, a Custom Spare Parts list, or analyzer
Certificates.
NOTE
To Next Page
Loading...
Need help?
General
