TRANSLATION OF THE ITALIAN ORIGINAL INSTRUCTIONS - 29 -
pliance automatically passes to the next. To start the cycle, press the FREEZING button: the freez-
ing led, the hard led and the probe led flash. Press the START/STOP button. The display will show
the temperature detected by the needle probe;
Soft freezing and conservation: negative soft chilling cycle (-18 °C at the core) and conserva-
tion. The cycle is divided into the soft freezing phase, the freezing phase, and the holding phase.
At the end of a phase, the appliance automatically passes to the next. To start the cycle, press
the FREEZING button: the freezing led, the hard led and the probe led flash. Press the SOFT/HARD
button: the hard led turn off. Press the START/STOP button. The display will show the tempera-
ture detected by the needle probe.
ATTENTION: in all phases, during conservation, the display will show the temper-
ature detected by the needle probe and the conservation led will light up in the
lower part of the display.
If the temperature detected by the probe does not reach the blast chilling/freez-
ing end value within the maximum expected duration, blast chilling will not be
completed correctly but will continue until the set cycle end phase temperature
is reached. The probe led will flash and the buzzer will be activated.
Timed operation
If the control unit does not detect temperature differences between the needle probe and the cell
probe (for example when the needle probe is left in its seat and not inserted in the product), the
appliance will emit a sound signal and the probe led will start flashing, before switching to timed
mode.
Estimated time for blast chilling cycles: 90 minutes;
Estimated time for freezing cycles: 240 minutes.
In this phase, the time can be modified using the UP and DOWN buttons on the control unit. After
the set time has elapsed, the appliance automatically switches to the holding phase.
Error messages displayed on the control unit:
Blast chilling cycle or temperature
freezing cycle not completed in
the estimated time
Disconnected or faulty probe
Check and/or replace
the probe
Disconnected or faulty probe
Check and/or replace
the probe
6. Cleaning and servicing
6.1 Safety instructions
Disconnect the appliance from the mains electricity supply (remove the plug
from the socket) before cleaning the appliance or starting any servicing or repair
activities;
Do not use aggressive detergent products and make sure that water does not enter the control
panel or inside the appliance’s technician chamber;
To prevent electric shock, never clean the appliance with a jet of water, and never immerse the
appliance or its parts, the power supply cable or the plug in water or any other liquid.
To Next Page
Loading...