Ammann ARX 23-2C - Loading the Machine; Loading the Machine Using a Ramp

100 ARX 23-2 T4i, ARX 26-2 T4i
MAX 30%
588009
2.8 Machine transport
2.8.1 Loading the machine
Use aloading ramp or acrane to load the machine onto amean
of transport.
2.8.1.1 Loading the machine using aramp
When loading the machine using aramp, all safety regulations
related to loading of the machine valid in the place of loading
must be adhered to. The ramp must have an appropriate load-
ing capacity, anti-slip surface and must be put on aat surface.
We recommend that you adhere to the BGR 233 regulation.
The maximum allowable inclination of the access ramp is 30%.
Use the loading mode to load the machine. Switch over the
travel mode selector (4) to position “0”.
When loading the machine, another person must be pre-
sent to give hand signals to the machine operator for
driving on the ramp. See the list of hand signals in chap-
ter 2.1.6.
Pay increased attention when loading the machine.
Improper handling can cause serious injury or death.
Non-adherence to the prescribed parameters of the ac-
cess ramp may result in damage to the machine.