EasyManua.ls Logo

Ammann ARX 23-2C - Coolant

Ammann ARX 23-2C
196 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
113ARX 23-2 T4i, ARX 26-2 T4i
2152
MAINTENANCE MANUAL
Water quality
Do not use hard water with ahigher content of calcium and
magnesium, which brings calculus formation, and with ahigher
content of chlorides and sulphates, which causes corrosion.
The maximum content of compounds of calcium and magne-
sium is 170 milligrams – hardness of water.
The maximum content of compounds of chlorine is 40 milli-
grams.
The maximum content of compounds of sulphur is 100 milli-
grams.
Safety instructions:
1) Protect your hands with protective gloves.
2) In case of ingestion immediately seek medical treatment.
3) In case of contact with skin or clothing immediately wash
the aected area with clean water.
4) Do not mix dierent types of coolants. The mixture can
cause achemical reaction with formation of harmful sub-
stances.
3.2.3 Coolant
The coolant specication must meet requirements of:
- SAE J1034
- SAE J814c
To ll the cooling circuit, use the coolant in the mixing
ratio of 50%/50% with high-quality water (thermal pro-
tection up to -37°C).
Change the coolant every 2 years at the latest.
Note
The machines are lled with acooling solution with the Bant-
leon Avia Antifreeze NG coolant, specication SAE J 1034 at the
manufacturer's during the production.
It is acoolant containing silicates based on monoethylene gly-
col. It does not contain phosphates, nitrates, amines and bo-
rates.
There is an Avia NG label placed where the coolant is to be lled
into the machine.
Rell the cooling circuit with the same or acompletely
miscible coolant of the required specication.
If the use of a dierent, immiscible coolant is neces-
sary, the cooling circuit must be completely drained and
cleaned with clean water repeatedly, at least 3 times.
However, it is not allowed to use acoolant of adierent
specication than stated by the engine manufacturer.
The coolant protects the cooling system from freezing,
corrosion, cavitation, overheating etc.
It is forbidden to operate the machine without coolant
even for ashort time.
It is forbidden to use acoolant of adierent than pre-
scribed specication and base. The engine and the cool-
ing system can get damaged and the warranty lost.
Always check the ratio of antifreeze cooling agent in the
coolant with a refractometer before the winter season
starts.

Table of Contents

Related product manuals