Ammann ARX 23-2C - Checking the Oil in the Hydraulic Tank

123ARX 23-2 T4i, ARX 26-2 T4i
588041
593022
1
MAINTENANCE MANUAL
3.6.4 Checking the oil in the hydraulic tank
Check the hydraulic oil level always when the engine is cold but
running.
Put the machine on aat terrain.
Let the engine run at idle.
Check the oil level in the inspection hole.
The ideal oil level is when the gauge is half-full.
Hydraulic oil relling
Take o the ventilation lter (1) from the ller neck.
Rell the required quantity of hydraulic oil.
Screw in the ventilation lter (1) back in place.
Always lubricate the O-ring before screwing it in place.
Check the oil when it is cooled down.
Fill up the same oil type; see Chap. 3.2.4.
Stop the oil soaking into the ground.