140 ARX 23-2 T4i, ARX 26-2 T4i
1
2
3
3.6 Lubrication and maintenance operations
3.6.20 Tyre pressure check
On combined rollers, check the tyre pressure with a tyre pres-
sure gauge and adjust if necessary. The pressure is factory-set to
1 bar as standard.
The tyre pressure must be adjusted to the degree of soil com-
paction.
• Tyre pressure OK (1)
• Tyre pressure too low (2)
• Tyre pressure too high (3)
Pay attention to the equal pressure in all of the tyres.
When fabric is visible on the tyre surface, the tyres must
be replaced.
To Next Page
Loading...
