75ARX 23-2 T4i, ARX 26-2 T4i
OPERATING MANUAL
2.7.5 Machine parking
Shut down the machine on aat and solid surface where there is no potential natural hazard (e.g. landslides, ooding).
Change the travel control (11) to the brake position (P).
Switch over the key in the ignition box (19) to the position “0”, take out the key from the ignition box and close the lid.
Turn o the battery disconnector if it is installed in the machine.
Clean the machine from dirt.
Check the whole machine and repair defects that occurred during operation.
Lock the cover of the dashboard and the engine bonnet with apadlock.
Note
The padlock is not delivered in the machine equipment.
Protect the dashboard and the engine compartment from unauthorized access of others by locking the dashboard cover and the
engine bonnet.
It is forbidden to use the parking brake for bringing the machine to astop.
2.7.6 Panic response
The immediate stop of the machine using the travel control (11) applies to all of the travel modes of the machine. When the travel
control (11) is changed to the opposite position through (0) within 1 second, the machine will stop – the parking brake will be engaged
and the engine will keep running, i.e. panic response. When the machine vibration is on, the vibration will stop also when the manual
vibration mode is selected. The machine can start moving again after the travel control (11) is changed to the parking brake position
(P) and the travel direction (F/R) is selected.
It is forbidden to use the panic response for common stopping the machine. Enable the panic response only in emer-
gency when the machine must be stopped immediately.
To Next Page
Loading...
