Ammann ARX 23-2C - Machine Operation in Dusty Environment; Driving with Vibration on Compacted and Hard Materials

106 ARX 23-2 T4i, ARX 26-2 T4i
2.9 Special conditions to use the machine
2.9.7 Machine operation in dusty
environment
While operating in a very dusty environment, shorten
cleaning and replacement intervals of air lter cartridg-
es and shorten cleaning intervals of coolers.
The recommended cleaning interval is once aweek.
2.9.8 Driving with vibration on compacted
and hard materials
When the machine works with vibration on hard materials (e.g.
loose stony materials) or materials with ahigh degree of com-
paction, the drum can lose its contact with the compacted ma-
terial (so-called vibro stroke). Due to this condition, the transfer
of vibrations to the machine frame and to the driver’s stand in-
creases. It can be partly removed by increasing the travel speed
or by changing the vibration parameters of the machine (using
asmaller amplitude).
If it is necessary to work with the machine in conditions when
the operator can be exposed to higher vibrations, the machine
user must modify working procedures to protect the driver's
health.
Note
When driving with vibration on adierent background material
than specied in the Specication manual, the emission values
of the vibration acceleration will be dierent – Noise and vibra-
tion emissions.