165ARX 23-2 T4i, ARX 26-2 T4i
MAINTENANCE MANUAL
Low-pressure piping and lter venting:
Prepare asuitable vessel.
Connect the fuel lter bleeding hose and insert the other end
into the catch pan.
Turn the key in the ignition box to position I.
The fuel pump starts working (it is audible).
Loosen the bleeding screw on the fuel lter.
Bleed the system – no air bubbles appear in the hose.
Tighten the screw.
Loosen the valve for about 10 seconds and retighten.
Start the engine.
Note:
If the engine does not start or stops immediately after starting,
bleed the fuel system again.
Do not bleed when the engine is hot, the leaking fuel can
cause are.
Follow safety regulations!
Do not smoke and do not use an open ame while work-
ing on the fuel system!
Stop the fuel soaking into the ground!
To Next Page
Loading...
