Ammann ARX 23-2C - Page 175

171ARX 23-2 T4i, ARX 26-2 T4i
Error on thedisplay Description
F42 Asphalt Temperature sensor failure
F45 ACE frequency out of range
F46 ACE amplitude low
F48 ACE timeout on CAN
F50 [SF] SF2.4 - SafetyFunction Parking brake monitoring
F51 CAN_BUS0 error
F52 CAN_BUS1 (ECU-Engine-Levers) error. Displayed as EBUS.
F53 CAN_BUS2 error
F54 SW failure safety
F55 SW failure non safety
F56 Machine ECU failure
F57 ECU sensor supply failure
F58 Machine ECU temperature out of range
F59 Error list failure
F60 Engine type autodetection failed
F61 Engine CAN communication lost
F62 [HW] Alternator error - P-terminal output not detected
F63 [HW] Engine speed is too high - above SETPOINT_B
Error on thedisplay Description
F70 [SF] SF2.1 - SafetyFunction Drive pump diagnostic
F71 [SF] SF2.2 - SafetyFunction Operator presence detection hard ramp
F72 [SF] SF2.3 - SafetyFunction Emergency stop
F73 [SF] SF2.5 - SafetyFunction Drive lever position validation
F74 [SF] SF2.6 - SafetyFunction Parking brake diagnostic
F76 [SF] SF3.1 - SafetyFunction Drive lever crosscheck
F77 [SF] SF3.2 / SF3.7 - SafetyFunction Operator presence detection soft ramp
F78 [SF] SF3.3 - SafetyFunction Gear switch pump limitation
F79 [SF] SF4.1 - SafetyFunction Drive lever CAN validation external input lever right
F80 [SF] SF4.1 - SafetyFunction Drive lever CAN validation
F81 [SF] SF4.2 - SafetyFunction Drive lever Emergency Stop - panic reaction
F82 [SF] SF4.7 - SafetyFunction Drive lever presence
F83 [SF] SF6.1 - SafetyFunction Gear switch crosscheck
F84 [SF] SF7.1 - SafetyFunction Drive lever autodetection
MAINTENANCE MANUAL
The texts are given only in the original language version or as atranslation of the original into the English language version.The texts are given only in the original language version or as atranslation of the original into the English language version.
Safety function errors