Ammann ARX 23-2C - Page 181

177ARX 23-2 T4i, ARX 26-2 T4i
Displayed
message
Description of the displayed message Note
btnCAL Calibration button pressed
btn br Brake test button pressed
br tSt Brake test active
rA SEL Ramp selection
HArd Hard ramp
SoFt Soft ramp
tEMP Temperature unit selection
C Celsius
F Fahrenheit
LEFtLu Left lever presence selection
OFF O - left lever not present
On On - left lever present
tc SEL Rear drum type (tandem/combi) selection
tAndEM Tandem
CoMbI Combi
Saue Save (menu item)
SAuIn9 Saving
SAuEd Saved
btnOFF O button pressed
Error Error when saving new parameters values
PUMP Pump calibration (menu item)
CUrr Current in mA Current (to the forward/reverse travel coil) during calibration, the
value in [mA] is shown in the upper display
SUCC Success The calibration of minimum currents to travel coils successfully
completed
FAIL Failure Error in the calibration of minimum currents to travel coils – values
have not been changed
bAC Back One step back in the menu structure
UndEF Undened Unspecied error (contact the service centre)
dPFErr DPF error No message about the DPF lter status received from the engine.
MAINTENANCE MANUAL
The texts are given only in the original language version or as atranslation of the original into the English language version.The texts are given only in the original language version or as atranslation of the original into the English language version.
Messages displayed on the display