Ammann ARX 23-2C - Page 67

63ARX 23-2 T4i, ARX 26-2 T4i
OPERATING MANUAL
Start-up procedure using leads from an external power supply:
The starting supply from the external power supply must be 12V.
Always follow the undermentioned operation sequence.
1/ Connect one end of the (+) pole of the cable to the (+) pole of the discharged battery.
2/ Connect the other end of the (+) pole of the cable to the (+) pole.
3/ Connect one end of the (–) pole of the cable to the (–) pole of the external battery.
4/ Connect the other end of the (–) pole of the cable to any part of the started machine, which is attached to the engine (or with the
engine block itself).
When the engine has been started, disconnect cables in reverse order.
Do not connect the (–) pole of the cable to the (–) pole of the discharged battery of the machine being started! During
the starting heavy sparking may occur and gases of the charged battery may explode.
Uninsulated parts of clamps of the jump leads must not touch each other!
The jump lead connected to the (+) pole of the batteries must not come into contact with electrically conductive parts
of the machine – danger of ashort circuit!
Do not lean over the batteries – possibility of electrolyte burns!
Remove ammable sources (open ame, burning cigarettes, etc.)
Do not check the presence of voltage in the wire by sparking against the machine frame!