8 Maintenance
BNNbOO
ID: 1138310 Issue date January 01, 2010
97
Roller maintenance
ATTENTION!
Not all maintenance tasks are listed in these operating and maintenance
instructions. With regard to the Yanmar engine, please observe the
maintenance table on the following page! We would also like to point out the
separate manual for the Yanmar engine.
NOTE
Maintenance may only be carried out by trained specialized personnel!
• When carrying out maintenance work always observe the applicable safety
regulations in the Safety section.
• Maintenance work and inspections must be performed according to the
following maintenance tables in order to guarantee reliable machine
operation. The individual points are described in detail on the following
pages.
• Remove all dirt before taking off any covers, plugs, measuring rods, etc. to
inspect or top up engine oil, hydraulic oil, diesel or other liquids.
• Any parts that do not pass the following inspections must be replaced
immediately.
• The protective devices must be correctly refitted after every service.
Every 10 operating hours (daily)
• Inspect engine oil level.
• Inspect coolant.
• Inspect fuel level and fill up tank.
• Inspect hydraulic oil level.
• Inspect sprinkler system.
• Inspect scrapers, adjust or replace if necessary
• Inspect condition of roller drums
• Check that the tire pressure on the pneumatic wheel axis is 2.5 bar
To Next Page
Loading...
