Programming
43
Instruction Manual - Solecis Digital Switchers
Video SEND_COMMANDs (Cont.)
VIDIN_HDCP Sets the video input HDCP compliance setting of the video input port addressed by the
D:P:S. When VIDIN_HDCP is disabled, the addressed video input will appear to any
source as not being HDCP compliant. For computer sources that encrypt all video when
connected to an HDCP compliant display, disabling HDCP compliance on the input will
cause the computer to send non-encrypted video which can then be routed to
non-compliant displays and video conferencing systems.
Note: It may be necessary to disconnect and re-connect PC sources after changing this
setting.
WARNING! Disabling HDCP compliance for sources that do not support non-compliant
displays (such as DVD and Blu-Ray players) is not recommended and may affect Solecis
performance.
Syntax:
SEND_COMMAND <DEV>, "'VIDIN_HDCP-<option>'"
Variables:
option = ENABLE, DISABLE (default = ENABLE)
Example:
SEND_COMMAND VIDEO_INPUT_1,"'VIDIN_HDCP-ENABLE'"
Enables the HDCP compliance of video input port (#1 based on D:P:S).
Note: Only applicable on HDMI ports of Solecis switchers (not VGA inputs).
?VIDIN_HSHIFT Requests the input Horizontal shift of the VGA video port addressed by the D:P:S.
Syntax:
SEND_COMMAND <DEV>, "'?VIDIN_HSHIFT'"
Example:
SEND_COMMAND VIDEO_INPUT_1,"'?VIDIN_HSHIFT'"
Returns a COMMAND string of the form: VIDIN_HSHIFT-<value>.
VIDIN_HSHIFT Sets the horizontal shift of the video port addressed by the D:P:S to <value>.
Note: This command is only valid for VGA inputs.
Syntax:
SEND_COMMAND <DEV>, "'VIDIN_HSHIFT-<value>'"
Variables:
value = -50..50
Example:
SEND_COMMAND "'VIDIN_HSHIFT-2'"
Sets the Horizontal shifting of the video input port (#1 based on D:P:S) to 2 (shift to right).
SEND_COMMAND "'VIDIN_HSHIFT--3'"
Sets the horizontal shifting of the video input port (#1 based on D:P:S) to -3 (shift to left).
?VIDIN_PHASE Requests the input phase of the video port addressed by the D:P:S. This command is valid
only for inputs whose format is set to VGA.
Syntax:
SEND_COMMAND <DEV>, "'?VIDIN_PHASE'"
Example:
SEND_COMMAND VIDEO_INPUT_1,"'?VIDIN_PHASE'"
Returns a COMMAND string of the form: VIDIN_PHASE-<value>.
VIDIN_PHASE Sets the input phase of the video port addressed by the D:P:S to <value>. This command
is valid only for inputs whose format is set to VGA.
Syntax:
SEND_COMMAND <DEV>, "'VIDIN_PHASE-<value>'"
Variables:
value = 0..31
Example:
SEND_COMMAND VIDEO_INPUT_1,"'VIDIN_PHASE-23'"
Sets the phase of video input port to 23.
To Next Page
Loading...
Need help?
General
