AMX TPI-PRO-DVI-2

NetLinx Programming
108
TPI-PRO-DVI - Instruction Manual
Run Time Operation Commands (Cont.)
@AKR Remove keyboard or keypad that was displayed using 'AKEYB', 'AKEYP', 'PKEYP', @AKB, @AKP, @PKP, @EKP, or @TKP
commands.
Syntax:
"'@AKR'"
Example:
SEND COMMAND Panel,"'@AKR'"
Removes the Keyboard/Keypad.
BEEP Output a beep.
Syntax:
"'BEEP'"
Example:
SEND COMMAND Panel,"'BEEP'"
Outputs a beep.
BRIT Set the panel brightness.
Syntax:
SEND_COMMAND <DEV>,"'BRIT-<brightness level>'"
Variables:
• brightness level = 0 - 100.
Example:
SEND_COMMAND Panel,"'BRIT-50'"
Sets the brightness level to 50.
@BRT Set the panel brightness.
Syntax:
SEND_COMMAND <DEV>,"'BRIT-<brightness level>'"
Variables:
• brightness level = 0 - 100.
Example:
SEND_COMMAND Panel,"'BRIT-70'"
Sets the brightness level to 70.
DBEEP Output a double beep.
Syntax:
"'DBEEP'"
Example:
SEND COMMAND Panel,"'DBEEP'"
Outputs a double beep.
@EKP Extend the Keypad. Pops up the keypad icon and initializes the text string to that specified. The Prompt Text is optional.
Syntax:
"'@EKP-<initial text>;<prompt text>'"
Variables:
initial text = 1 - 50 ASCII characters.
prompt text = 1 - 50 ASCII characters.
Example:
SEND COMMAND Panel,"'@EKP-33333333;Enter Password'"
Pops up the Keypad and initializes the text string '33333333' with prompt text 'Enter Password'.