AMX TPI-PRO-DVI-2

NetLinx Programming
91
TPI-PRO-DVI - Instruction Manual
Button Commands (Cont.)
^BIM Set the input mask for the specified address.
Syntax:
"'^BIM-<vt addr range>,<input mask>'"
Variables:
• variable text address range = 1 - 4000.
• input mask = Refer to the Text Area Input Masking section on page 9 for character types.
Example:
SEND_COMMAND Panel,"'^BIM-500,AAAAAAAAAA'"
Sets the input mask to ten ’A’ characters, that are required, to either a letter or digit (entry is required).
^BLN Set the number of lines removed equally from the top and bottom of a composite video signal. The maximum number of
lines to remove is 240. A value of 0 will display the incoming video signal unaffected. This command is used to scale non
4x3 video images into non 4x3 video buttons.
Syntax:
"'^BLN-<vt addr range>,<button states range>,<number of lines>'"
Variables:
• variable text address range = 1 - 4000.
• button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons, 1 = Off state and 2 = On state).
• number of lines = 0 - 240.
Example:
SEND_COMMAND Panel,"'^BLN-500,55'"
Removes 55 lines from the top and 55 lines from the bottom of the video button.
^BMC Button copy command. Copy attributes of the source button to all the destination buttons. Note that the source is a single
button state. Each state must be copied as a separate command.
• The <codes> section represents what attributes will be copied.
• All codes are 2 character pairs that can be separated by comma, space, percent or just ran together.
Syntax:
"'^BMC-<vt addr range>,<button states range>,<source port>,<source address>,
<source state>,<codes>'"
Variables:
• variable text address range = 1 - 4000.
• button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons 1 = Off state and 2 = On state).
• source port = 1 - 100
• source address = 1 - 4000
• source state = 1 - 256
•codes:
BM - Picture/Bitmap
BR - Border
CB - Border Color
CF - Fill Color
CT - Text Color
EC - Text effect color
EF - Text effect
FT - Font
IC - Icon
JB - Bitmap alignment
JI - Icon alignment
JT - Text alignment
LN - Lines of video removed
OP - Opacity
SO - Button Sound
TX - Text
VI - Video slot ID
WW - Word wrap on/off
Example 1:
SEND_COMMAND Panel,"'^BMC-425,1,1,500,1,BR'"
or
SEND_COMMAND Panel,"'^BMC-425,1,1,500,1,%BR'"
Copies the OFF state border of button with a variable text address of 500 onto the OFF state border of button with a
variable text address of 425.
Example 2:
SEND_COMMAND Panel,"'^BMC-150,1,1,315,1,%BR%FT%TX%BM%IC%CF%CT'"
Copies the OFF state border, font, Text, bitmap, icon, fill color and text color of the button with a variable text address of
315 onto the OFF state border, font, Text, bitmap, icon, fill color, and text color of the button with a variable text address
of 150.