AMX UDM-0808-SIG - A;V Source Input Connectors; VIDEO in Connectors (HD15); Connecting a VGA Video Input; Connecting a Composite Video Input

UDM-0808-SIG Wiring and Connections
7
UDM-0808-SIG, UDM-RX02N and UDM-ABB-8-SIG Operation /Reference Guide
A/V Source Input Connectors
There are eight sets of input connectors to the rear panel of the UDM-0808-SIG, labelled A - H (FIG. 7).
VIDEO IN Connectors (HD15)
FIG. 8 provides the pin layout for the VIDEO IN HD15 Connectors:
Connecting a VGA Video Input
1.
Connect one end of a VGA cable to the source device’s VGA output port.
2. Attach the other end of the cable to the appropriate VIDEO IN connection (A-H) on the UDM-0808-SIG.
3. Connect the source audio to the analog (RCA) audio jacks, or digital (SPDIF) Input connector.
Connecting a Composite Video Input
1.
Connect the UDM-HD15RCA3 Breakout Cable (FG-HD15RCA3, not included) to the source device’s
Composite output ports:
A1 = red RCA
2. Attach the other end of the cable to the appropriate VIDEO IN connector (A-H) on the UDM-0808-SIG.
3. Connect the source audio to the analog (RCA) audio jacks, or digital (SPDIF) Input connector.
FIG. 7 A/V Source Input connectors (A and B shown)
FIG. 8 VIDEO IN HD15 Connector
Video Input (female HD15)
Digital Audio Input (SPDIF)
RCA Audio Inputs (L/R)
12345
678910
1112131415
HD15 Pinouts
Input Pin
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
VGA
Red
Red - Ground
Green
Green - Ground
Blue
Blue - Ground
Horz. Synch
Vert. Synch
n/c
Ground
n/c
Ground
n/c
n/c
n/c
Component
Pr
Pr - Ground
Y
Y - Ground
Pb
Pb - Ground
n/c
n/c
n/c
n/c
n/c
n/c
n/c
n/c
n/c
S-Video
Luminance
Luminance - Ground
n/c
n/c
Chrominance
Chrominance - Ground
n/c
n/c
n/c
n/c
n/c
n/c
n/c
n/c
n/c
Composite
CVBS1
CVBS1 - Ground
CVBS2
CVBS2 - Ground
CVBS3
CVBS3 - Ground
n/c
n/c
n/c
n/c
n/c
n/c
n/c
n/c
n/c
Ensure the UDM Hub port to which the RX02N Receiver is attached is configured
correctly (via NetLinx programming). Also ensure the correct Audio Type (Analog L/R,
S/PDIF, or None) is selected for the relevant input.