AMX UDM-0808-SIG User Manual

UDM-RX02N IR File Transfers
65
UDM-0808-SIG, UDM-RX02N and UDM-ABB-8-SIG Operation /Reference Guide
8. Click OK to close the Select Files For File Transfer dialog, and return to the File Transfer dialog. The IR
file should now appear in the Files To Send queue (FIG. 59).
9. Click Send to transfer the file.
If the Host UDM-0808-SIG Hub has Firmware version v0.70 or higher, the Hub does not have to be
rebooted before the IR file transfers.
If the Host UDM-0808-SIG has a Firmware version v0.55, the Hub must be rebooted. When the
UDM-0808-SIG is rebooted, it will transfer IRL files to the target RX02Ns. If you have multiple
RX02Ns connected to the UDM-0808-SIG Hub, complete all file transfers to the RX02Ns first,
then reboot the Hub to update all of the RX02Ns at once.
Additional Documentation
For additional information on using NetLinx Studio, refer to the NetLinx Studio online help and Operation/
Reference Guide (available at www.amx.com).
FIG. 58 Select Files for File Transfer dialog - Files To Send queue (NetLinx Studio)
FIG. 59 File Transfer dialog (NetLinx Studio)

AMX UDM-0808-SIG Specifications

General

Brand	AMX
Model	UDM-0808-SIG
Category	Receiver
Language	English