Analytik Jena qTOWER3 - Safety symbols on the qTOWER³; Technical condition

Safety instructions
8 Edition 03.19 qTOWER
3
/ qTOWER
3
G
2.2 Safety symbols on the qTOWER³
The qTOWER³ is fitted with safety symbols, the content of which must always be ob-
served. Damaged or missing safety symbols can cause incorrect actions leading to
personal injury or material damage! The safety symbols must not be removed! Dam-
aged safety symbols must be replaced without delay!
The following safety symbols are attached to the qTOWER³ and accessories:
Warning symbol
Mandatory action signs
(on heatable lid)
(on equipment backplate)
Warning against a
hazard location
Warning against
hot surface
Before opening the device al-
ways disconnect the mains plug
The following notice sign is attached to the rear of the qTOWER
3
:
2.3 Technical condition
The qTOWER³ corresponds in its design and construction to the current state of the art
technology. Unauthorized modifications or changes, especially such that affect the safe-
ty of the staff and the environment, are generally not allowed.
Observe the following:
 Any manipulation of the safety equipment is prohibited! In case of an accident
manipulations of the safety equipment will be interpreted as deliberate!
 The operator must only operate the device in a sound and operationally safe
condition. The technical condition must always comply with the legal require-
ments and regulations.
 Prior to every use the device must be checked for damage and sound condition.
 Any changes in the device affecting its safety must be reported by the operating
personnel to the operator without delay.