EasyManua.ls Logo

Analytik Jena qTOWER3 - Storage; 11 Disposal

Analytik Jena qTOWER3
46 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Disposal
42 Edition 03.19 qTOWER
3
/ qTOWER
3
G
For the setup at the new location observe the notes in section "Installation con-
ditions" p. 19.
10.5 Storage
NOTICE
Possible device damage due to environmental conditions and condensation water.
The device must only be stored in air-conditioned rooms. The atmosphere must be low in
dust and free from aggressive vapors.
If the device is not installed immediately after delivery or not required for prolonged pe-
riods, it should be stored in its original packaging. A suitable desiccant should be added
to the equipment to prevent damage from moisture.
The following requirements are placed on the climatic conditions in the storage room of
the qTOWER³:
Temperature range: +5 °C to +55 °C
Max. humidity: 10 % to 30 %
11 Disposal
The operator of the qTOWER³ must dispose the waste materials that occur during
measurements (sample materials) in accordance with the statutory and local regula-
tions.
At the end of its service life, the qTOWER³ and all its electronic components must be
disposed of as electronic waste in accordance with valid regulations.

Table of Contents

Related product manuals