Analytik Jena qTOWER3 - Fig. 10 Position A1 on the Sample Block

Operation
qTOWER
3
/ qTOWER
3
G Edition 03.19 31
3. Place the PCR plates onto the thermal block in such a way that well A1 is on the
left-hand side (arrow in the figure below). This position corresponds to the well al-
location in the qPCRsoft program.
Fig. 10 Position A1 on the sample block
4. Close the lid. To do so, fold the lid forward and press it down from the handle until
the lock engages with a click.
5. Start the PCR run in the qPCRsoft program.