Analytik Jena qTOWER3 - Return; Moving the Qtower³ in the Laboratory

Transport and storage
qTOWER
3
/ qTOWER
3
G Edition 03.19 41
10.3 Return
WARNING
Risk of damage to health due to improper decontamination!
Before returning the device to Analytik Jena AG perform a professional decontamination.
NOTICE
Analytik Jena AG must refuse acceptance of contaminated devices. The sender may be
liable for any damage caused by inadequate decontamination of the device.
 Please clean all device components from biologically hazardous, chemical and
radioactive contamination (see "Disinfecting the device" p. 33).
 The decontamination protocol is provided by the service when the return is reg-
istered. Complete the form and attach the signed decontamination declaration
to the outside of the shipment.
 Only use the original packaging for the shipment and insert the transport lock.
If the original packaging is no longer available, please contact Analytik Jena AG
or your local distributor.
 Please attach the warning note
"CAUTION!
SENSITIVE ELECTRONIC DEVICE!" to the packaging.
 Please include a sheet containing the following data:
− Name and address of the sender
− Name and telephone number of a contact for inquiries
− A detailed description of the fault, the precise conditions and situations under
which the fault occurs.
10.4 Moving the qTOWER³ in the laboratory
CAUTION!
Risk of injury if the device falls!
Move the qTOWER³ with great care. 2 persons are required to lift and carry the device. They
should position themselves on both sides of the equipment.
Since the device does not have handles, grip the device firmly with both hands at the lower
end, lifting it simultaneously.
Observe the following when moving the device within the laboratory:
 Disconnect the mains connection and the PC from the device.
 Observe the guide values and adhere to the legally mandated limits for lifting
and carrying without auxiliary means!