- 17 -
Programming of valve-group irrigation
The selector should be returned to the TIME/DAY mode
following modification or ending of the program.
As stated, the controller allows for two types of valve programming:
1. Programs A, B, and C – programming designated for a group of valves.
2. Independent Program I – separate programming for each individual valve independently. For this
program, turn to page 21.
Controller Programming for a Valve Group (A,B, and C)
• To select Program A, or B, or C, or to select a Lighting Program (for the lighting program see page
28), turn selector to the Program Choice Mode.
• One of the three programs will appear on the display panel – press on
until the desired program
appears, for example A. (The
symbol for the lighting program will also appear, see page 28).
• In order to select the program press on
. The word OFF will begin to blink. Pressing the
button will make the button blink. Program A has been selected.
• By pressing the
button the program will be closed (OFF). The program is no longer operating.
• Note that at this stage continue with weekly/cyclical programming (Pages 16/18).
To Next Page
Loading...