- 20 -
Programming of valve-group irrigation
2. Cyclic Irrigation Programming
The controller is programmed to operate the selected program at set cyclic times. The
cycle can be set from one day up to 30 days. The cyclic time will be identical for all of
the valves attributed to the selected program.
Cycle Time Selection
• Turn selector to WEEKLY / CYCLIC mode (in Programs A, B and C)
• Press on
until symbol and DAYS 1 appear (Irrigation cycle of 1 day).
• Press on
. DAYS 1 blinks.
• Set cycle time using
or as necessary up to DAYS 30.
Starting Irrigation Cycle for Cyclic Programming
In this operation the time and day for starting cyclic irrigation of the rst valve is set (in cyclic
programming there is only one start time). All of the valves attributed to the designated
program will open in sequential order. As the rst valve closes, the second will open and
so forth.
The number of days preceding the start of the program must be set. 0 DAYS - irrigation
will start as of that day, 1 DAYS - irrigation will start the following day and so forth. Days
preceding start of cycle irrigation may be up to 14 days. .
• Turn selector to START mode (Programs A, B and C). STARTS I, and the last displayed
starting time or OFF will appear on display panel.
• Press on
. Hour digits will blink. Set the desired starting time using the and as necessary.
• Press on
. Minute digits will blink. Set the desired minutes for the starting time using the and
as necessary.
• Press on
until the number 1 and the word DAYS appear on appear on display panel. Set number
of days preceding start of cycle with
or as necessary.
To Next Page
Loading...