Anritsu ML2400A Series - Page 168

Re turned
String: TRGARM <c>,<state>
The TRG type com mands re turn the trig ger state of the se lected chan -
nel if the chan nel is ON. This de pends on the set tings of the “link trig -
gers” flag and the cur rent mode of the sen sor on the se lected chan nel. If
the chan nel is OFF, the stored trig ger state of the chan nel is re turned.
TRGDLY Trig ger sam ple de lay
TRIG GER
Syn tax: TRGDLY <c>, <val>[units]
c: 1, 2 or 1&2
val: 0.0 to 1.0 sec onds
Re marks: The time the sys tem waits af ter a trig ger event has hap pened
be fore tak ing mea sure ments when in READ OUT or POWER vs. TIME
mode.
Se lect chan nel 1, 2 or 1&2. Se lecting 1&2 al lows both chan nels to trig ger
to gether on the same con di tions with out hav ing to set up two sets of
trig ger data.
Query: TRGDLY? <c>
Re turned
String: TRGDLY <c>,<val>
The TRG type com mands re turn the trig ger state of the se lected chan -
nel if the chan nel is ON. This de pends on the set tings of the “link trig -
gers” flag and the cur rent mode of the sen sor on the se lected chan nel. If
the chan nel is OFF, the stored trig ger state of the chan nel is re turned.
TRGGW Set trig ger gate width
TRIG GER
Syn tax: TRGGW <c>,<val>[units]
c: 1, 2 or 1&2
val: 100 ns to 7.0 sec onds
Re marks: The length of time the sys tem uses to col lect data when in READ OUT or
POWER vs. TIME mode. The de fault value is 20 ms.
Se lect chan nel 1, 2 or 1&2. Se lecting 1&2 al lows both chan nels to trig ger
to gether on the same con di tions with out hav ing to set up two sets of
trig ger data.
Query: TRGGW? <c>
Re turned
String: TRGGW <c>,<val>
ML2400A OM 6-81
GPIB OPERATION ML24XXA NATIVE COMMANDS