10580-00176 14
Identifiers
The following identifiers have been used throughout the remote command definitions.
Descriptions are provided here. In most cases, units will be specified with the individual
command.
Identifier Description
<amplitude>
Amplitude value. Units specified with the command.
<freq>
Frequency. Units specified with the command.
<integer>
Integer value, no units. Range specified with the
command.
<number>
Numeric value, integer or real.
<percentage>
Percentage value from 0-100. Units are always “%”.
<rel ampl>
Relative amplitude. Units are always dB.
<x-parameter>
Parameter value in the units of the x-axis. Units are
specified with the command.
<string>
The string should be enclosed in either single quotes (‘ ’)
or double quotes (“ ”).
<file name>
The name should be enclosed in either single quotes (‘ ’)
or double quotes (“ ”). The need for an extension will be
documented with applicable commands.
<voltage>
Voltage. Units specified with the command.
<current>
Current. Units specified with the command.
To Next Page
Loading...
Need help?
General
