To Next PageTo Next Page
Need help?Do you have a question about the Anritsu S820E and is the answer not in the manual?
General| RBW | 1 Hz to 3 MHz |
|---|---|
| VBW | 1 Hz to 3 MHz |
| Amplitude Accuracy | ±0.5 dB |
| Frequency Range | 9 kHz |
| Display | color LCD |
| Interfaces | USB, LAN |
| Measurement Parameters | Power |
Guidance on preventing Electrostatic Discharge (ESD) damage to sensitive instrument circuits.
Procedure for measuring Return Loss and VSWR to verify transmission feed line performance.
Procedure for testing signal attenuation level of a cable system using cable loss measurements.
Reveals fault location in transmission lines, aiding in identifying specific problems like mismatches or kinks.
Describes how to set up Cable and Antenna parameters, including frequency, distance, amplitude, and limit lines.
Provides access to calibration procedures, including start, update, info, interpolation, and correction settings.
Parameters to set before calibration: Cal Type, Cal Line, Port DUT, and Port Cal Kit.
Detailed steps for performing calibrations, including setup, measurement, and verification.
Menu options for VNA calibration, including start, update, info, interpolation, and correction.
Setting up parameters like Cal Type, Cal Line, Cal Method, DUT, Cal Kit, and Thru Device.
Step-by-step guide for performing VNA calibrations, including saving and recalling coefficients.
Comparison of VVM Calibration vs. Save Reference and performing absolute/relative measurements.
Procedures for connecting USB sensors and setting up measurement parameters like frequency and amplitude.
Initiates zero calibration of the sensor and provides access to calibration information.
Procedure for saving measurements, setups, or screen shots to internal memory or USB drive.
Enables recalling measurement, setup, or screen shot files from internal memory or USB.
