S820E UG PN: 10580-00343 Rev. H A-3
Instrument Messages A-1 Introduction
20. Saving File…Failed: An error was encountered while saving the file.
The save process was aborted. Check that the destination location is
accessible and try again. If the problem persists, then the current setup
may have corrupted parameters or data. Preset the instrument and try
saving the file again.
21. USB drive missing. Please connect one to either USB port:
No USB flash drive was found while copying log files. Check that the
USB drive is installed correctly and try again.
22. Verifying easyTest File ... : When an easyTest file is first opened, a
check is performed to ensure that the file is compatible with the
instrument and that the file is not corrupted. After the verification
passes the file is recalled. If it fails, then a message box is displayed
with more specific information about the failure.
23. Zero Sensor completed: The zeroing function performed on the
attached USB power sensor has been completed.
To Next Page
Loading...
