Anritsu S820E - Freq;Dist Menu (Continued); DTF Setup

6-24 PN: 10580-00343 Rev. H S820E UG
6-8 Freq/Dist Menu VNA Mode
Freq/Dist Menu (Continued)
Key Sequence: Freq/Dist
DTF Setup
DUT Line Type (Coax WG): Press this submenu key to
toggle the line type between Coaxial cable and Waveguide.
See Figure 6-16 on page 6-25 for the waveguide submenu
keys.
Cable List: The Cable List submenu key opens a list of
available cable specifications. Using Up/Down Arrow keys,
the rotary knob, or the touchscreen, select the desired cable
and press Enter. See Figure 6-17 on page 6-26 for an
example of the cable and waveguide lists.
Note: When a cable is selected from this list, propagation
velocity and cable loss are automatically set by the
instrument. If the preselected values for propagation velocity
or cable loss are changed, then the analyzer will use “NONE”
as the cable type.
Cable Loss: Press the Cable Loss (or Waveguide Loss)
submenu key and enter the loss in dB/ft or dB/m for the
selected cable (or Waveguide) by using the keypad,
Up/Down Arrow keys, or the rotary knob, and then press
Enter.
Prop Velocity: Press the Prop Velocity submenu key and
enter the applicable propagation velocity for the selected
cable by using the keypad, Up/Down Arrow keys, or the
rotary knob, and then press Enter.
Cutoff Freq: Press this waveguide submenu key and enter
the applicable cutoff frequency in Hz for the selected
waveguide by using the keypad, Up/Down Arrow keys, or
the rotary knob, and then press Enter. See Figure 6-16
on page 6-25 for the waveguide submenu keys.
Windowing: Opens the “Windowing Menu” on page 6-27.
Figure 6-15. Frequency/Distance Menu (2 of 2)
Freq/Dist
Frequency
Cable List
Cable Loss
DTF Setup
Prop Velocity
Windowing
Nominal Side
Lobe
d
owin
g
ina
l
Si
de
Lobe
Distance
DUT Line Type
C
C
a
a
a
b
b
bl
e
Li
s
t
DUT Line Typ
Coax WG