Anritsu S820E - Sweep Trigger Menu

3-68 PN: 10580-00343 Rev. H S820E UG
3-18 Sweep Trigger Menu Cable and Antenna Measurements
3-18 Sweep Trigger Menu
Key Sequence: Sweep (3) > Sweep Trigger
Sweep Trigger
Continuous: Sets the sweep trigger to internal and
continuous, and sets the Run/Hold setting to Run. A new
sweep is triggered automatically at the end of each sweep.
This is the default sweep trigger setting.
Single: Sets the sweep trigger to internal and single, and
sets the Run/Hold setting to Hold. Each sweep is activated
by the Run/Hold submenu key.
Ext. Trigger: Sets the sweep trigger to an external source.
Each sweep is activated by a TTL signal at the External
Trigger In connector. Refer to “Test Panel Connector
Overview” on page 2-3.
Figure 3-48. Sweep Trigger Menu
Sweep Trigger
Continuous
Sweep
T
C
o
nt
i
n
u
Single
Ext. Trigger