Anritsu S820E - 3-7 Measurement Setup

S820E UG PN: 10580-00343 Rev. H 3-29
Cable and Antenna Measurements 3-7 Measurement Setup
3-7 Measurement Setup
This section briefly describes how to setup the Cable and Antenna
parameters, markers, and limit lines.
Frequency
Setting up the Measurement Frequency using Start and Stop Frequencies
1. Press the Freq/Dist main menu key then Frequency if the menu is
collapsed.
2. Press the Start Freq (F1) submenu key and enter the start frequency
using the Up/Down Arrow keys, rotary knob or keypad. When using the
keypad, the button labels change to GHz, MHz, kHz, and Hz. Press the
appropriate unit key to complete the entry.
3. Press Stop Freq (F2) and enter the stop frequency.
Distance
1. Press the Freq/Dist main menu key and then Distance if the menu is
collapsed.
2. Press the Start Distance (D1) submenu key and enter the start distance
using the Up/Down Arrow keys, rotary knob or keypad. When entering
a distance using the keypad, press the unit key to complete the entry.
3. Press Stop Distance (D2) and enter the stop distance.
DTF Aid
Refer to “DTF Measurement Examples” on page 3-18.
Amplitude
Setting the Amplitude using Top and Bottom Keys
1. Press the Amplitude main menu key.
2. Press the To p submenu key and use the keypad, rotary knob, or the
Up/Down Arrow keys to edit the top scale value. Press Enter to set.
3. Press the Bottom key and use the keypad, rotary knob, or the Up/Down
Arrow keys to edit the bottom scale value. Press Enter to set.