14
14
EN
R7
- OPERATING INSTRUCTION
3.1. R7 line operating unit conversion
WARNING!
accidentally be turned on, creating hazardous situations.
a
k
NOTE: slightly move arms on their pivot points so as to
make element release easier.
WARNING!
During this operation, avoid extending the arms of the
operating lamp, if any, to the outside so as to prevent any
excessive imbalance of the equipment.
b
WARNING!
Be extremely careful not to pinch the suction tubes and
instrument cords while performing this operation.
NOTE: make sure that element ( k ) is correctly locking short
arm in the new position.
c
WARNING!
If the stop pin is not used, the arm may bang against the
hydrogroup damaging it during regular operation.
a
WARNING!
Before attempting to turn on the operatory unit, verify all
the equipment is in the correct work condition.
To Next Page
Loading...
