68
68
EN
R7
- OPERATING INSTRUCTION
7.4. BIOSTER/S automatic disinfection system
Description of the system.
To run the disinfection cycle, operate as follows:
A) Preparing the disinfectant solution:
NOTE: Make sure that the tank is completely lled.
B) Setting the BIOSTER S cycle:
a
NOTE: the BIOSTER/ S cycle can only be activated if the
SHS/S system is enabled (icon A on).
d
WARNING!
Use the adapter ( f ) provided for the syringe. The heater should be
The syringe on the assistant's board cannot be disinfected using the
BIOSTER S cycle.
The micromotor cord must be completed with motor body.
Turbine and scaler cords must be inserted without the handpiece.
e
g
C) Executing the BIOSTER S cycle:
NOTE: in the rst 5 seconds the disinfectant is also delivered
by the cup water fountain.
D) Disinfectant contact time:
E) Duct rinsing phase
.
NOTE: in the rst 20 seconds the liquid is also delivered by
the cup water fountain.
To Next Page
Loading...
