EasyManua.ls Logo

Anthos SMART TOUCH R7 - 5.1.1.2.1.2. Flushing CYCLE SETTING

Anthos SMART TOUCH R7
90 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2525EN
R7
- OPERATING INSTRUCTION
5.1.1.2.1.2. Flushing CYCLE SETTING

         

 

NOTE: this submenu cannot be entered if the distilled water tank
is low (see paragraph 7.2.). A message on the control panel display and an
acoustic signal (BEEP) will signal the impossibility to enter the submenu.
 or .
NOTE: the time may range from at least 1 minute to at most 5
minutes, with 1 minute intervals.
NOTE: for the distilled water tank, it is advisable not to set a time
longer than 2 minutes.







NOTE: the syringe is always active, therefore as soon as it is in-
serted in the instrument container it will immediately start delivering water.
NOTE: the Flushing CYCLE does not start if at least one instrument
is not selected.
 


Table of Contents

Related product manuals