5252
EN
R7
- OPERATING INSTRUCTION
board.
NOTE: instrument activation is indicated by the relative management
page appearing on the TOUCH DISPLAY.
NOTE: The curing light has a permanent memory therefore the
last cycle used will always be present the next time it is used.
NOTE: The ber optic should be placed as close to the material
to be cured as possible without touching it.
WARNING!
Operation: runs 2 consecutive cycles, rests 60 seconds.
NOTE: When a programmed cycle is activated, the LEDs (1, 2,
3, B, R, L) indicate the time that elapses (in multiples of 5 seconds) and
turn o every 5 seconds of operation.
WARNING!
• The curing light is equipped with a system that signals malfun-
paragraph).
• The curing light is equipped with a cut-out.
Indicators.
• LED 5 and LED 1, green, constantly on.
• LED 5 and LED 2, green, constantly on.
• LED 5 and LED 3, green, constantly on.
•
Maximum curable thickness.
WARNING!
This thickness must not be exceeded as the layer may not be completely cured.
To Next Page
Loading...
