79
[Ring function]: Enable is function before using the Ring time settings.
[Wiegand Mode]: Wiegand26, Encrypted wiegand.
[Fixed Wiegand area code (0~254)]: If you upload one fingerprint to two
terminals, the same fingerprint’s wiegand outputs are different in the different
terminals. If the two terminals’ wiegand area codes are same, the same fingerprint’s
wiegand outputs are same in these two terminals.
[Lock Relay time (0~15 second)]: The door open delay.
[Default identification method on the device]: Set identification method for the
device. Such as: Fingerprint , Fingerprint+Password, Fingerprint+Password+Card
ID+Password, ID+ Fingerprint, ID+Password+Fingerprint, Card, Card+Password,
Card+Fingerprint etc.
Click the button [OK] to save the settings. Following message box pops up:
Click the button [OK] to confirm or click the button [Cancel] to cancel.
The operation information in the main interface is as follows:
Click the button [Display Default setting] to see the terminal’s default settings
5.1.8 Ring Settings
Set the ring time. Please enable the Ring function in the parameter settings first
of all.
Click the button [Ring settings]. [Set ring time] window pops up as follows:
[2011-08-25 15:05:08]Set Advanced Parameter...
[2011-08-25 15:05:10]1[Head office]Parameter setting successfully!
To Next Page
Loading...
Need help?
General
