What to do if my AnyTone Two-Way Radio has no power?
There are several possible reasons: * The battery may be depleted. Recharge or replace the battery. * The battery may not be installed correctly. Remove the battery and install it again. * The power switch is broken. Contact local dealer for repair. * Battery tabs or the connection is broken. Contact local dealer for repair.
What to do if I can receive voice but cannot transmit on my AnyTone Two-Way Radio?
Check the [PTT] key.
Why can't I talk to or hear other members in my group on my AnyTone Two-Way Radio?
This could be due to several reasons: * Different frequency or channel - please change it. * Different CTCSS / DCS /DTMF - please reset it. * You may be out of communication range.
What to do if my AnyTone Two-Way Radio loudspeaker is quieter or has crackling sound?
Check whether the loudspeaker is broken, or if there is powder or dust in the loudspeaker. If the loudspeaker is broken, contact local dealer for repair.
Why does my AnyTone Two-Way Radio battery power die shortly after charging?
Replace the battery pack with a new one.
What to do if my AnyTone Two-Way Radio transmitting audio gets low or intermittent?
Check if the MIC hole is plugged. If not, contact local dealer for repair.
What to do if my AnyTone Two-Way Radio receiving indicator shows a green light but there is no sound?
This could be due to low volume, please turn the VOLUME knob clockwise. If the loudspeaker or earphone jack is broken, contact local dealer for repair. If the volume switch is broken, no solution is mentioned.
How to adjust static and noise on all bands of my AnyTone Two-Way Radio?
Adjust the squelch settings during programming.
What to do if there is no sound after removing earphone from my AnyTone Two-Way Radio?
Contact local dealer for repair.
General| Brand | AnyTone |
|---|---|
| Model | THE TERMINATOR TERMN-8R |
| Category | Transceiver |
| Language | English |
To Next Page
