27
SHORTCUT OPERATIONS
CTCSS/DCS Scan
Press
" icon, press key to
enter into CTCSS/DCS scan. Under this state, rotate the channel knob to change
the scanning direction. When the scan receives CTCSS/DCS signaling, it will stay
the scanning direction. When scan the matching CTCSS/DCS signaling, it will stay
5seconds and then continue scanning. Pre
, ,
NOTE: This function will not work when the transceiver is set up in the professional mode or the current
selected channel does not have any CTCSS/DCS signal first set up. If your current channel has its tone
signaling set as CTCSS, it will scan CTCSS, if its tone signaling is set as DCS, it will scan DCS.
Offset Frequency Direction Setup
When in standby, press " icon,
press
offset, Minus offset, remove offset.
(+) Plus offset:
1.
(-) Minus offset:
2.
None:
3. Indicates that the offset is off.
To Next Page
Loading...
Need help?
General
