10
INSTALLATION & CONNECTION
Installing the Additional Speaker/ Microphone (Optional)
Unveil the MIC-SP jack cover and then insert the
Speaker/Microphone plug into MIC-SP jack.
Note: The transceiver is not completely waterproof while
using the Speaker/Microphone.
Installing / Removing the Belt Clip
■ Installing the Belt Clip:
Place the belt clip to the grooves on the back of the
transceiver, and then install the screws, turning clockwise.
■ Removing the Belt Clip:
you to remove the belt clip.
To Next Page
Loading...
Need help?
General
