29
SHORTCUT OPERATIONS
Channel Scan Skip
Under channel mode, press
" icon,
then press
above operation to cancel channel scan skip.
1.
S
" means the current channel will not be scanned.
"2.
S
" icon disappeared means the current channel will be scanned.
Frequency/channel scan can change the scanning direction by rotating the channel knob, If a signal is
found the transceiver will stay 5 seconds then continue scanning. (Please refer to scan setup)
Frequency scan can be limited to UHF / VHF if you have the single band mode enabled (See: Function
Menu - Single Band Mode (VHF/UHF)
Frequency Scan can also be limited to your pre-set scanning border limits (See: Limit VFO frequency
scanning range)
If turn off radio in scan mode, when re-power on, radio will resume scanning automatically.
▼
▼
▼
▼
Frequency Reverse
When in standby, press
" icon,
then press
1. R
To Next Page
Loading...
Need help?
General
