BASIC OPERATIONS
VOLT:1.
CALL:
2.
FHSS (TERMN-8R Only):
3.
NOTE: The Receiver and the Sender must have the same hopping frequency, and must setup the MSK decode
signaling. Using FHSS may cause interference to sub band receive depending on frequency or setting of Menu
51 (sub-band mute).
ALARM:
4. "ALARM" and the transceiver
will enable the preset alarm function.
SUBPTT:
5.
"Dual PTT").
MONI:
6.
Transmit tone pulse frequency:
7.
NOTE: The tone pulse frequency can be set to 1750Hz, 1450Hz, 1000Hz or 2100Hz .
Clone Mode:
8.
cloning function (see the 'Cloning Cable' Section in this manual for more details)`
To Next Page
Loading...
Need help?
General
