Chapter 4 Arts and Letters 135
In the Canvas, the Sequence bounding box appears.
Before any animation occurs, you must explicitly add a parameter to the behavior from
within the Inspector. Until a parameter is added, Dashboard adjustments have no effect.
To use the Sequence behavior:
1 With the Sequence behavior selected, display the Behaviors tab in the Inspector.
The upper area of the Sequence controls contains the Add and Remove pop-up menus,
which are used to select parameters to add to the behavior or to remove parameters.
2505.book Page 135 Wednesday, June 30, 2004 5:58 PM
To Next Page
Loading...
