3.
Touch Next.
The Run Parameters screen is displayed:
Figure 20 Run Parameters screen
4.
Touch the
eld under Run ID, then enter the applicable information in the Enter
the Run ID screen.
The default Run ID is YYYYMMDDHHMM, where “YYYYMMDD” is the date
and “HHMM” is the current time.
You can choose to retain the default Run ID.
5.
Touch Add Comment to enter any comments about the run.
6.
Touch Start Run. The cover is heated to the required temperature, then the run
begins.
While the run is in progress, the Home screen is displayed. When the run is
complete, the Status Dial on the Home screen displays Done and Remove
Samples.
7.
Touch Done once you have removed the samples.
The Status Dial is now ready for another run and displays Set Up Run.
Use the Multi-Instrument Setup feature to perform runs on multiple instruments.
1.
In the Multi-Instrument Setup screen, touch the O and On toggle buon to
make the instrument on which you are running an experiment visible to other
instruments on the network.
2.
Touch the second set of O and On toggle buons to nd other instruments on
the network.
3.
Select an existing or new method and proceed to the Start Run screen.
Perform a run on
multiple
instruments
Chapter 3 Create and run experiments on the instrument
Perform a run
3
SimpliAmp
™
Thermal Cycler User Guide
23
To Next Page
Loading...
Need help?
General