Applied Biosystems SimpliAmp Thermal Cycler User Manual

d.
Lift and remove the cover from the instrument crate.
e.
Remove the packing material from the SimpliAmp
™
Thermal Cycler, then
inspect the instrument for shipping damage.
IMPORTANT! If the SimpliAmp
™
Thermal Cycler is damaged, note the
location and appearance of the damage, then contact Technical Support or
your service representative (see “Customer and technical support“ on
page 89).
2.
Move the SimpliAmp
™
Thermal Cycler to the desired installation site. Follow
these guidelines for lifting and moving:
• Make sure that you have a secure, comfortable grip.
• Keep your spine in a neutral position.
• Bend at the knees and lift with your legs.
• Do not lift and twist your torso at the same time.
3.
Verify that the package containing the SimpliAmp
™
Thermal Cycler Accessories
includes the SimpliAmp
™
Thermal Cycler Starter Kit.
Set up the system
1.
Remove the packing material:
a.
Open the SimpliAmp
™
Thermal Cycler heated cover.
b.
Using a can of compressed air, deliver a blast of air into each well of the
sample block(s) to remove any particles that may have collected during
transportation.
2.
Close the heated cover.
3.
Connect the power cable to the SimpliAmp
™
Thermal Cycler.
Figure 27 Power cable inlet in the SimpliAmp
™
Thermal Cycler
4.
(Optional) Install any of the recommended protective devices (see “Optional
protective hardware“ on page 38).
5.
Connect the power cable to the AC power source receptacle.
Appendix A
Install and connect to a network
Set up the system
A
SimpliAmp
™
Thermal Cycler User Guide 39

Applied Biosystems SimpliAmp Thermal Cycler Specifications

General

Brand	Applied Biosystems
Model	SimpliAmp Thermal Cycler
Category	Bicycle Accessories
Language	English