APS APS-3000P Series - Current and Multimeter Settings

CHAPTER 3
UNIT DESCRIPTION
Entire Contents Copyright  2004 by Adaptive Power Systems, Inc. (APSI) • All Rights Reserved • No reproduction without written authorization from APSI.
APS-3000P Series 3 - 6 OM-001-03000-00P-03.9
Current Selection
CURRENT display
Displays output current or the defined current value status and values
during SYSTEM/PROGRAM set-up.
LOCK indicator
When ON, the panel is in a locked state; the buttons are deactivated.
REMOTE indicator
When ON, the system is controlled by rear panel external switching.
Each system has two possibilities: PLC and either RS-232 or GPIB.
AUTO indicator
When ON, the system is in programmable mode.
MANUAL indicator
When ON, the system is in manual mode.
PROGRAM indicator
When ON, the PROGRAM parameter setting mode is active.
SYSTEM indicator
When ON, the SYSTEM parameter setting mode is active.
PROGRAM button
Enters / exits PROGRAM parameter set-up.
SYSTEM button
Enters / exits SYSTEM parameter set-up.
﹀ button
Steps the current / SYSTEM / PROGRAM parameters value down;
status select; and, sets current limit from 0.1 to system max.
︿ button
Steps the current / SYSTEM / PROGRAM parameters value up; status
select; and, sets current limit from 0.1 to system max.
APS-3000P Current Display
C U R R E N T
LOCK
REMOTE
AUTO
MANUAL
PROGRAM SYSTEM