arcelik A75 D 895 A - Page 96

ENGLISH
96
DETAILED CHANNEL SETTINGS
----------------------------------------------------
DiSEqC 1.0
– By using a satellite or switch, broadcasts
can be received from up to four different
satellites at the same time.
DiSEqC 1.1
– By using a satellite or switch, broadcasts
can be received from up to sixteen differ-
ent satellites at the same time.
15 Depending on your selection of »DiS-
EqC1.0« or »DiSEqC1.1«, 4 or 16 satellites
shall be displayed in the menu.
Note:
7
Example setup explained with 4 satellites
via »DiSEqC1.0«.
16 Select a satellite from the »Automatic Chan-
nel Search« menu with »
V « or » Λ « and
confirm with »

«.
17 Select the required elements with »
V «,
»
Λ «.
Satellite Status
Select »On« with »
<
« or »
>
«.
Satellite Selection
Press »

«, select the satellite you want
to scan with »
V «, » Λ « and confirm with
»

«.
Scan Mode
Select »Full« or »Network« with »
<
« or
»
>
«.
Scan Type
Press »
<
«, »
>
« to select »Free Channels
Only« for free channels only, »Encrypted
Channels Only« for encrypted channels or
»All« for all satellite channels.
Store Type
Press »
<
«, »
>
« to select »Digital Channels
Only« for television channels only, »Radio
Channels Only« for radio channels or »All«
for searching both.
18 Use »
V « or » Λ « to select »LNB Settings«
and confirm with »

«.
19 Select the required elements with »
V «,
»
Λ «.
LNB Power
»

« Select the LNB power » V « or » Λ «
button to select "13/18V" or "14/19V" and
confirm with »

« .
LNB Frequency
Press »

«, select LNB frequency used in
the satellite system with »
V « or » Λ « and
confirm with »

«.
DiSEqC Port
Press »

«.
– DiESqC Port menu is displayed.
Disable
DiSEqC A
DiSEqC B
DiSEqC C
DiSEqC D
Select »DiSEqC A«, »DiSEqC B«, »DiSEqC
C« or »DiSEqC D« to select the satellite
corresponding to the respective DiSEqC
positions in the satellite system.
Note:
7
If »Antenna Type«, »DiSEqC 1.1« is se-
lected, choose between »Uncommit 1« and
»Uncommit 16«.
20 Press »
a
« twice to return to »Automatic
Channel Scan«.
Note:
7
Make the settings described in steps 16 to
20 for other 3 satellites you want to scan.