99
ENGLISH
20 Confirm »Satellite Selection« by pressing
»
«, and press »
V
« or »
Λ
« to select the
satellite you want to scan.
21 Select »Scan Mode« with »
V
« or »
Λ
« and
select »Full« or »Network« with »
<
«, »
>
«.
22 Select »Scan Type« with »
V
« or »
Λ
«.
Press »
<
«, »
>
« to select »Free Channels
Only« for free channels only, »Encrypted
Channels Only« for encrypted channels or
»All« for all satellite channels.
23 Using »
V
« or »
Λ
« select »Store Type«.
Press »
<
«, »
>
« to select "All" to search for
both "Digital Channels Only" for TV chan-
nels only and "Radio Channels Only" for
radio channels only.
24 Use »
V
« or »
Λ
« to select »LNB Settings«
and confirm with »
«.
25 Using »
V
« or »
Λ
« select »Location« and
confirm with »
«.
Press »
V
« or »
Λ
« to select the location cor-
responding to the satellite you want to scan
and confirm with »
«.
26 Press »
a
« twice to return to »Automatic
Channel Scan«.
Note:
7
Make the settings described in steps 15
to26 for each satellite you want to scan.
27 Select »Next« with »
V
« or »
Λ
« and press
»
« to confirm.
– »Automatic Scan« menu shall be dis-
played and the scan for TV stations will
start.
– Scanning may take several minutes
depending on the number of television
stations received.
Notes:
7
Use set-up equipment supported/suggested
by your SCR Switch.
7
Other users / receivers connected to the
system may be affected if the specified user
band number and frequency are changed
during installation.
7
User band and User band frequency are
specified on the SCR switch used; and each
user / receiver must select a specified user
band and user band frequency.
7
With SCR satellite system, auto scan by
several users / receivers at the same time
may cause problems.
28 Press »
a
« to return to the previous menu,
press »
H
« to return to TV broadcast or
press »
T
« to return to Home menu.
DETAILED CHANNEL SETTINGS
----------------------------------------------------
To Next Page
Loading...
