ENGLISH
98
DETAILED CHANNEL SETTINGS
----------------------------------------------------
Automatic Channel
Scan
Proceed
Other
14 Select »Single Cable I« or »Single Cable II«
according to the type of single cable router
multi-switch in your antenna system, and
confirm with »
«.
Automatic Channel
Scan
Single
Tone Burst
DiSEqC 1.0
DiSEqC 1.1
DiSEqC 1.2
Single Cable I
Single Cable I
– By using a single channel router, a
maximum of 8 different devices can be
broadcast with the same cable.
Single Cable II
– By using a single channel router, a
maximum of 32 different devices can be
broadcast with the same cable.
15 Depending on your selection of »Single
Cable I« or »Single Cable II«, 8 or 32 user
bands are displayed in the »Tuner« menu.
Note:
7
Example setup is explained for 8 devices
via »Single Cable I«.
16 Select the required elements with »
V
«,
»
Λ
«.
Tuner
Press »
« and with »
V
«, »
Λ
« select
between »User band 1« and »User band 8«
and confirm with »
«.
Band Frequency
press »
« select the band frequency with
»
V
«, »
Λ
«, and confirm with »
« .
User Defined
You can set the band frequency yourself.
»When "User Defined" is selected in "Band
frequency", "User Defined" is displayed in
the Single Cabel I menu.
Enter the user defined frequency with
»1...0« and select »
« on the screen key-
board» and confirm with »
«.
17 Use »
V
« or »
Λ
« to select »Proceed« and
confirm with »
« button.
– Automatic Channel Scan menu shall be
displayed.
18 Select the first satellite displayed in the
menu with »
V
« or »
Λ
« and confirm with
»
«.
19 Select »Satellite Status« as »On« with »
<
«,
»
>
«.
To Next Page
Loading...
