Archos 404 - SETTING THE IR EMITTER CODE; IR Emitter Code Configuration

73
Before beginning this procedure
of setting the emitter code, your
device must be connected to
the DVR Station, which must be
powered with the charger/adapter.
The infrared control works through
the reection of the infrared signal
within a room. In order to improve the
reception of this infrared signal on
your tuner (VCR, cable or satellite box), you could rearrange the
position of the DVR Station and/or the tuner such that there are
more reective surfaces (furniture, a wall, etc. - see diagram).
Good communication between the DVR Station and your tuner
also depends on the sensitivity of your tuner’s IR receiver.
Setting the IR Emitter Code:
From the Home Screen, press to access the Setup Screen,
then highlight TV Control and press OK.
•
•
•