Archos 404 - Page 75

75
Test channel select: When you press the Test channel
select button (highlight test channel select and press OK),
the ARCHOS
™
device will send a signal through the DVR
Station’s infrared emitter and change the channel on your
tuner (VCR, cable box, or satellite receiver). If the Number
of digits parameter is set to three, it will try to select
channel 123. If that parameter is set to 2, it will send
the code for channel 12. If your tuner does not change
channels when you click on this test button, try the next
code for your device (step 2 above).
Test ON/OFF: When you click on the Test On/Off button, the
ARCHOS
™
device will send a signal to the infrared emitter
and turn your device on or off. Press this test button again
and your device should change from on to off or off to on.
If pressing this button does not turn your device on or off,
try the next code for your device (step 2 above). If none of
the codes work, check that the DVR Station is positioned
in a way that allows the IR signal to reach your tuner
device’s receiver. Note: In some rare cases the ON/OFF
functionality may not work.
Tune channel select: These four parameters usually do not
need to be set. Keep the default values to start with.
Key: -/--
Set this to On if normally, you have to press this same key
on your device’s remote control in order to select a channel.
Number of digits
Set the number of digits that your device can recognize
for a channel. Example: Set to 3 if you need to choose a
channel greater than channel 99.
Key: Enter
Set this to On if normally, you have to press the OK button
on your device’s remote control after you enter the channel
number. Example: If you normally press 1, 3, OK for
channel 13, then you would need to set this parameter to On.
3.
4.
5.
•
-
•
-
•
-